Skip to content

Alerts

Alerts can be setup to Alert you when you fall below or above a set min max range. There are six type of alerts:

  • Any

    Use this to apply a specific alert to your entire activity.

  • Warm Up

    Use this to apply a specific alert to any of the Warm Up phases in your active Intervals.

  • Active

    Use this to apply a specific alert to any of the Active phases in your active Intervals.

  • Rest

    Use this to apply a specific alert to any of the Rest phases in your active Intervals.

  • Recovery

    Use this to apply a specific alert to any of the Recovery phases in your active Intervals.

  • Cool Down

    Use this to apply a specific alert to any of the Cool Down phases in your active Intervals.

To set the alert type, tap the Toggle icon in the centre of the alert to cycle through each:

Off, Heart Rate, Power, Speed, Pace

Once selected, set the Min and Max value of the Alert range you wish to remain in. If you prefer to choose a zone (1-5) to stay in, tap the Toggle icon in the top right corner to cycle through each zone until you get to your preferred zone. The min and max for the Alert will be selected from the currently active Zones for the Profile.

Info

Alerts set on individual laps within your Profiles active Intervals will take precedence over any alerts set here for the same lap type.

Options

  • Out For

    The duration you must be continuously be outside of your set range before being alerted.

  • Sleep

    The duration to sleep between alerts before raising another alert (maximum alert frequency)

  • High Warning

    Warning feedback configuration for when you are over the max range value

  • Low Warning

    Warning feedback configuration for when you are under the min range value

  • Popup Duration

    This setting determines how long, in seconds, the designated Alert screen is displayed in your Layout after an Alert occurs.

Tip

The designated Alert screen includes measures from the Alerts measure category, providing a summary of the Alert. Modify this screen to add or change your preferred Alert measures by editing your Layout

Alerts can be modified directly within a profile, or you can create shared Alerts in the Library and link them to any profiles. This offers the added benefit of centralized editing and management for Alerts that are used across multiple Profiles.

If you have previously setup Alerts in the Library you can link them to your profile by tapping on the left hand icon with the List Selector. This will show a list of available library Alerts for selection.